Видео

Do not remove the egr unless you plan on doing a custom MAP computer otherwise you'll get some funky idling problems

I did this in the fuel and crankcase on a SHO. Put the seafoam in a week before i changed it. 260 miles later it was the blackest oil ive ever pulled out of any engine. I think it works.

I gotta f-250 1995 5.8 v8 obs. Just curious, why would I do this? More power or better mpg? What's the point

My friend always used it on the vacuum lines

Good stuff I have to ask because we all know Honda's are picky, but can I do this to my 1990 Honda Accord ex has 250,000+ runs and starts like a champ just like taking care of my stuff.(First car)

3M Ceramic IR side windows = blue tint shade. Crystalline front windshield = brownish tint. Sure hope you like the contrast in colors in the cabin.

How much do you spray in carb 4cil 1 carb

If had read or watched the official seafoam RUclips channel video you can add an entire 20 Oz bottle to 4 gallons. It's made of high-quality consecrated petroleum that will not hurt your engine.

Hi was you able to get the Resistors put in for the EGR delete, im looking to see how you did that. thanks

Not sure if I missed it but how did you end up plugging where the egr tube connected at the exhaust manifold?

where'd you get that hat? my brother just got a wildtrak, wanna get it for him

So, my external reservoir fell off my shock recently. It looks like it was welded on. Will this be a warranty item?

Did anyone ever put it in the 2019 Chevy trax

naaah! windshield washer fluid while highway cruising.

Did just using the kill mat actually make a difference in the road noise?

What muffler do you have?

I'm a little concerned about excessive use of fuel additives - they WILL foul plugs (not that big a problem), but worse they can shorten life of catalytic converter

Good video except for saying something the company recommended to change out after 100-300 miles can be left a full oil change. Sure seafoam says its safe except good luck getting them to pay if a problem happens, prove it is what they'll say not ok we'll replace your motor. They also have notes it can make your oil dirty, depending on condition of your crankcase and motor. So it's rather irresponsible to advocate oh thats ok without a caveat. Such as except or if you suspect your motor is dirty or has lots of sludge it may not be good to leave in long.

QUESTION: In the past, when my Cub Cadet push mower stopped working as a result of running out of gas, the gas tank was virtually empty. You couldn't see anything at all left in the gas tank. But now when the mower stops running - presumably from having no fuel - there is actually quite a bit of visible "liquid" in the gas tank. Does anyone know why this is?

you looking to cause a protest?, them that go mad because of wef, wef will send the zombies around to protest about 🤣

Hmmm Spend just over $300 just to remove all of this ? Seems cheaper just to leave it alone.....

Why is the coffee can back? I thought it was deleted

Any plans to do a Solid Axle Swap? I never liked the TTB front setup in the 80 to 96 Fords. I bought a '95 F150 new with the straight 6, 5 speed manual, 3.73 gears and limited slip front and rear. It was great, but, I always missed having a solid axle up front like in the 4 70's Fords I had before and the 2001 F 250 Superduty I had after it. That's a sweet Bronco though. Can't wait to see what you do next.

Flowmaster are some of the worst flowing mufflers ever.

Had a 91 Eddie Bauer with 5.8 and custom flow master duals…way way back in the day 1996 before it was cool.

This does not work on a 96, computer won’t allow!

Do you have a link for the kit?? And is it for the 5.8??

Brother, in the video you don't say what you did with the tube that comes out of the intake chamber, if you covered it or what you did with it.

Could I use it on an 2012 Impreza wrx sti

I did this to my car then after letting it sit for 10 minutes / heat sink. I took it on the highway! 🤣🤣

You are one lucky man! I was waiting for that straw to get sucked off... Those straws fly off the cans all the time from just spraying them... You got by with spraying an entire can and still didn't pop off...

Whoa, you showed a mess of new parts purchased to go in the Bronco right at the end. Did you video those upgrades? Will those be posted soon? I’m not ever going to buy a new Bronco, but I am actively shopping for a 94-96 Bronco and I want to see videos on these upgrades!! Let’s go!!!

FACT - Windsor sounds best through a flowmaster muffler

u have sold me on a bronco

I can even feel how would it smell if had been there! 😂😂

Did you cover the exhaust manifold hole under the egr with anything?

How often do they need to be emptied?

thanks for the plethora of mat reviews and testing so i didn’t have to 😂

I bought the 3Ws for my 2023 based on Chase's previous review. I think they're great, completely happy with that purchase.

So when i did mine, I didn't replace the air pump I just got a smaller belt and there were. O issues

Will my air conditioning still work ? Gotta have it 😂

How do you empty them?

Nice video however I would point out that I'm sure see foam does it by fluid ounces not by ounces by weight???

Should do a update video when you service them. Great video.

Can I use it only on fuel tank?

Just watched Tom Seguras video and guess about 100-120k...over 200k?!?! NOOOOPE! Not even if I was rich for a FORD! hahahaha

Those new Broncos are cool. But I hope they bring back these larger 90s Broncos.